Revolabs Microphone 75 User Guide

Revolabs Single Channel Wireless Microphone System- Tandberg Edge

75/85/95 MXP Setup Guide

NOTES AND CAUTIONS:

This setup guide will guide you through the step needed to properly connect a Revolabs

Single Channel System to a Tandberg Edge 75/85/95 MXP video codec.

1. Connecting the Cables

2. Configuring the Edge MXP Video Codec

Note: It is important to carefully follow these instructions in order and completely.

Otherwise your Single Channel System and/or the video codec may not function

properly. Please read through these instructions completely before proceeding.

Contact Revolabs technical support if you have any questions.

Requirements for connecting systems:

1. Revolabs Single Channel System

2. Tandberg 880 MXP video codec

3. QTY 1 07-STEMIC-PPP Line-to-Mic Interface Cable*

* OPTIONAL FROM REVOLABS

NOTE: IMAGES OF SET UP SCREENS ARE DEFAULT SETTINGS FROM TANDBERG AND ARE PART OF THE

TANDBERG MXP ADMINISTRATOR’S GUIDE © MAY 2008

Configuring the Edge 75/85/95 MXP Video Codec

CONFIGURING THE AUDIO MENUS OF THE EDGE MXP VIDEO CODEC

Go to AUDIO SETTINGS

Select INPUTS

Confirm that MIC 1 is ON

Adjust the audio Input Type Level if necessary (recommend +8dB)

Speak into the Revolabs microphones that are connected to MIC 1.

The audio meter should peak at about 5dB for normal speech.

Return to previous menu and select ECHO CONTROL

Enable MIC 1 Echo Canceller (ON)

Return to previous menu and select AUDIO LEVELING (AGC)

Turn MIC Audio Leveling (AGC) OFF